Design of magnet power supply system for Quasi-Axisymmetric test of Chinese First Quasi-Axisymmetric Stellarator
-
摘要: CFQS 装置是中国西南交通大学(SWJTU)和日本国家核融合科学研究所(NIFS)联合设计制造的中国首台准环对称仿星器,为满足装置0.1 T稳态运行的实验要求,需要为其磁体线圈设计相应的电源系统。本设计方案考虑工程实际估算线路阻抗,考虑工程裕度、电源以负载参数的1.2倍进行计算,并建立电源系统的Simulink仿真模型,分析负载电流纹波大小及网侧谐波含量。根据仿真结果优化设计方案,通过在直流侧增加无源滤波器,减小输出电流纹波,分析直流侧电压代数形式,计算滤波器参数,并仿真调节得到更加符合实际需求的滤波器参数,满足装置准环对称位形的分布磁场精度对磁体线圈电流纹波的要求。Abstract: Chinese First Quasi-Axisymmetric Stellarator (CFQS) is being constructed as an international joint project between the National Institute for Fusion Science in Japan and Southwest Jiaotong University in China. To meet the requirements of 0.1 T steady-state quasi-axisymmetric magnetic field configuration experiment, it is necessary to design and manufacture the corresponding power supply system for its magnet coil. Since the power grid capacity of the laboratory can’t achieve the power consumption required for 0.1 T operation of CFQS, the magnet coil power supply system uses 500 kVA energy storage power station, and the main circuit of the magnet coil power supply system adopts bridge thyristor rectification. In this design scheme, the line impedance is estimated according to the actual engineering situation. Considering the engineering margin, we calculate the power supply at 1.2 times of the actual load parameters, and build the Simulink simulation model of the power supply system to analyze the load current ripple and the harmonic content of the grid side. According to the simulation results, we optimize the design and reduce the output current ripple by adding a passive filter at the DC side. By this way, the output current ripple can meet the requirements of the quasi-axisymmetric magnetic field configuration.
-
表 1 磁体线圈参数
Table 1. Parameters of coils
No. ${R_{\rm{d}}}$/mΩ ${L_{\rm{d}}}$/mH ${I_{\rm{d}}}$/A MC1 435.67 82.52 450 MC2 429.50 81.12 450 MC3 415.62 78.74 450 MC4 401.23 75.97 450 TFC10 228.13 3 220 TFC32 210.00 2.7 220 TFC70 173.57 2.16 220 OV 230.59 18.85 450 IV 73 5 450 -
[1] Kinoshita S, Shimizu A, Okamura S, et al. Engineering design of the Chinese First Quasi-Axisymmetric Stellarator (CFQS)[J]. Plasma and Fusion Research, 2019, 14: 3405097. doi: 10.1585/pfr.14.3405097 [2] Liao Jianquan, Zhou Niancheng, Wang Qianggang. Design of low-ripple and fast-response DC filters in DC distribution networks[J]. Energies, 2018, 11: 3128. doi: 10.3390/en11113128 [3] Wang Y L, Wang Yingqiao, Mao Xiaohui. Simulation of ohmic heating power supply for HL-2M[J]. IEEE Transactions on Plasma Science, 2014, 42(10): 3197-3201. doi: 10.1109/TPS.2014.2321752 [4] Liu Haifeng, Shimizu A, Xu Yuhong, et al. Configuration characteristics of the Chinese first quasi-axisymmetric stellarator[J]. Nuclear Fusion, 2021, 61: 016014. doi: 10.1088/1741-4326/abbc85 [5] 张政权, 刘庆想, 向欣, 等. 高频整流谐振变换电源[J]. 强激光与粒子束, 2010, 22(4):721-724 doi: 10.3788/HPLPB20102204.0721Zhang Zhengquan, Liu Qingxiang, Xiang Xin, et al. High-frequency rectifying commutated converter[J]. High Power Laser and Particle Beams, 2010, 22(4): 721-724 doi: 10.3788/HPLPB20102204.0721 [6] Rummel T, Füllenbach F, Mönnich T. Power supplies for the WENDELSTEIN 7-X stellarator[J]. Fusion Engineering and Design, 2003, 66/68: 1115-1118. doi: 10.1016/S0920-3796(03)00252-7 [7] 毛晓惠, 李青, 王雅丽, 等. 基于脉冲调制技术的LHCD大功率阴极高压电源[J]. 强激光与粒子束, 2016, 28:015004 doi: 10.11884/HPLPB201628.015004Mao Xiaohui, Li Qing, Wang Yali, et al. LHCD cathode high voltage power supply based on pulse step modulator[J]. High Power Laser and Particle Beams, 2016, 28: 015004 doi: 10.11884/HPLPB201628.015004 [8] 张俊婷, 吴命利, 叶晶晶. 基于Matlab/Simulink牵引整流变压器的建模研究[J]. 电气化铁道, 2016(s1):14-18Zhang Junting, Wu Mingli, Ye Jingjing. Research on modeling of traction rectifier transformer based on MATLAB/Simulink[J]. Electric Railway, 2016(s1): 14-18 [9] 高亚静, 苗宏佳, 吴文传, 等. 三相变压器模型分析及其对配电潮流的影响[J]. 中国电力, 2014, 47(6):49-54 doi: 10.3969/j.issn.1004-9649.2014.06.010Gao Yajing, Miao Hongjia, Wu Wenchuan, et al. Comparison of different transformer models and their influences on power flow of three-phase distribution system[J]. Electric Power, 2014, 47(6): 49-54 doi: 10.3969/j.issn.1004-9649.2014.06.010 [10] Marouchos C, Darwish M K, El-Habrouk M. New mathematical model for analysing three-phase controlled rectifier using switching functions[J]. IET Power Electronics, 2010, 3(1): 95-110. doi: 10.1049/iet-pel.2008.0328 [11] 李普明, 徐政, 黄莹, 等. 高压直流输电交流滤波器参数的计算[J]. 中国电机工程学报, 2008, 28(16):115-121 doi: 10.3321/j.issn:0258-8013.2008.16.019Li Puming, Xu Zheng, Huang Ying, et al. Algorithm for the parameters of AC filters in HVDC transmission system[J]. Proceedings of the CSEE, 2008, 28(16): 115-121 doi: 10.3321/j.issn:0258-8013.2008.16.019 [12] Liserre M, Blaabjerg F, Hansen S. Design and control of an LCL-filter-based three-phase active rectifier[J]. IEEE Transactions on Industry Applications, 2005, 41(5): 1281-1291. doi: 10.1109/TIA.2005.853373 [13] Wang Fei, Chen Gang, Boroyevich D, et al. Analysis and design optimization of diode front-end rectifier passive components for voltage source inverters[J]. IEEE Transactions on Power Electronics, 2008, 23(5): 2278-2289. doi: 10.1109/TPEL.2008.2001895 [14] 王宇. 基于Matlab/Simulink的12脉波整流电路谐波分析[J]. 电气技术, 2013, 14(10):25-27 doi: 10.3969/j.issn.1673-3800.2013.10.006Wang Yu. Analysis for 12-pulse rectifier on Matlab/Simulink[J]. Electrical Engineering, 2013, 14(10): 25-27 doi: 10.3969/j.issn.1673-3800.2013.10.006 [15] 曾江涛, 孙凤举, 许日, 等. 50 kV/4 A输出高压恒流电源[J]. 强激光与粒子束, 2000, 12(1):111-114Zeng Jiangtao, Sun Fengju, Xu Ri, et al. 50 kV/4 A high voltage constant current supply[J]. High Power Laser and Particle Beams, 2000, 12(1): 111-114