| Citation: | He An, Ding Yu, Kang Junjun, et al. Accurate control technology of 24 modules in PTS[J]. High Power Laser and Particle Beams, 2018, 30: 035003. doi: 10.11884/HPLPB201830.170353 |
| [1] |
丰树平, 李洪涛, 谢卫平, 等. Z箍缩初级实验平台模块样机[J]. 强激光与粒子束, 2009, 21 (3): 463-467. http://www.hplpb.com.cn/article/id/3955
Feng Shuping, Li Hongtao, Xie Weiping, et al. Development of prototype module of Z-pinch primary test stand. High Power Laser and Particle Beams, 2009, 21 (3): 463-467 http://www.hplpb.com.cn/article/id/3955
|
| [2] |
He An, Li Fengping, Deng Jianjun, et al. Primary investigation into the laser triggering multi-gap multi-channel gas switch in a single test module facility[J]. Plasma Sci Technol, 2006, 8 (5): 602-606.
|
| [3] |
Matzen M K, Sweeney M A, Adams R G. Pulsed-power-driven high energy density physics and inertial confinement fusion research[J]. Phys Plasmas, 2005, 12 : 055503. doi: 10.1063/1.1891746
|
| [4] |
Weinbrecht E A, Bloomquist D D, McDaniel D H, et al. Update of the Z Refurbishment project (ZR) at Sandia National Laboratories[C]//16th IEEE International Pulsed Power Conference. 2007: 975-978.
|
| [5] |
Rogowski S T, Bliss D E, Adams R G. A study of timing jitter improvements on Z with a new laser triggering system[C]//14th IEEE International Pulsed Power Conference. 2003: 1371-1374.
|
| [6] |
Weinbrecht E A, Bloomquist D D, McDaniel D H. Status of the Z Refurbishment Project (ZR) at Sandia National Laboratories[C]//15th IEEE International Pulsed Power Conference. 2005: 170-173.
|
| [7] |
Savage M, LeChien K, Stygar W. Overview and status of the upgraded z pulsed power driver[C]//IEEE International Power Modulator and High Voltage Conference. 2008: 93.
|
| [8] |
Li Hongtao, Xie Weiping, Feng Shuping, et al. Development of a high-reliability low-jitter 6 MV/300 kJ Marx generator[J]. Plasma Sources Sci Technol, 2008, 17 : 015001. doi: 10.1088/0963-0252/17/1/015001
|
| [9] |
Woodworth J R, Molina I, Nelson D. Green-laser-triggered water switching at 1. 6 MV[J]. IEEE Trans Dielectrics and Electrical Insulation, 2007, 14 (4): 951-957.
|