Application of coaxial wire method in impedance measurement of small aperture vacuum component

Sun Yuansheng; Tian Saike; Wang Na; Yue Sen; Zhang Yuan

doi:10.11884/HPLPB202234.210439

Volume 34 Issue 2

Jan. 2022

Turn off MathJax

Article Contents

Article Navigation > High Power Laser and Particle Beams > 2022 > 34(2): 024002

Sun Yuansheng, Tian Saike, Wang Na, et al. Application of coaxial wire method in impedance measurement of small aperture vacuum component[J]. High Power Laser and Particle Beams, 2022, 34: 024002. doi: 10.11884/HPLPB202234.210439

Citation:

Sun Yuansheng, Tian Saike, Wang Na, et al. Application of coaxial wire method in impedance measurement of small aperture vacuum component[J]. High Power Laser and Particle Beams, 2022, 34: 024002. doi: 10.11884/HPLPB202234.210439

Citation:

PDF( 1223 KB)

Application of coaxial wire method in impedance measurement of small aperture vacuum component

doi: 10.11884/HPLPB202234.210439

Sun Yuansheng^{1, 2
,},
Tian Saike^{1
,
,},
Wang Na¹,
Yue Sen^{1, 2},
Zhang Yuan^{1, 2}

1.
Institute of High Energy Physics, Chinese Academy of Sciences, Beijing 100049, China
2.
University of Chinese Academy of Sciences, Beijing 100049, China

Received Date: 2021-10-18
Rev Recd Date: 2021-11-24

Available Online: 2021-12-01

Publish Date: 2022-01-11

Abstract

Abstract

In particle accelerators, the impedance of vacuum components is an important cause of beam instabilities. Smaller emittance is required in the new generation storage-ring-based light source, where smaller vacuum chamber is needed and the impedances are increased correspondingly.Therefore, the impedance of the vacuum components should be evaluated accurately and well optimized during the design stage. Impedance measurement is an important way to check the impedance model. The coaxial wire method is commonly used for laboratory bending measurements. For small-aperture vacuum components, the measurement error caused by the inner conductor is studied in this paper. For narrow-band impedances, pillbox cavity is used to study the influence of different inner conductor radius on the measurement results. As benchmarks, different numerical simulations, such as wake field, scattering parameters and eigenmodes, are carried out. The results show that the simulations are in good agreement with the measurement. It is also found that there exist deviations between the measurement and the existing theories on the dependence of the resonant frequency shift on the inner conductor radius. For non-narrowband impedances, we measured the impedance of a strip line kicker and studied the influence of the inner conductor, which verified the validity of the coaxial wire method.
- coupling impedance,
- particle accelerator,
- small aperture,
- impedance measurement,
- coaxial wire method,
- frequency shift

FullText(HTML)

References(12)

References

[1]	Sands M, Rees J. A bench measurement of the energy loss of a stored beam to a cavity[R]. Menlo Park, CA: SLAC National Accelerator Lab, 2016.
[2]	王光伟. BEPC储存环纵向阻抗的测练[D]. 北京: 中国科学院高能物理研究所, 1989 Wang Guangwei. Impedance measurement of BEPC storage ring[D]. Beijing: Institute of High Energy Physics, Chinese Academy of Sciences, 1989
[3]	黄刚. 纵向耦合阻抗测量及束流反馈系统的研究[D]. 北京: 清华大学, 2002 Huang Gang. The study of coaxial line method longitudinal coupling impedance measurement and beam feedback system[D]. Beijing: Tsinghua University, 2002
[4]	周德民. BEPCII储存环真空部件纵向阻抗计算和测量[D]. 北京: 中国科学院高能物理研究所, 2005 Zhou Demin. Longitudinal impedance calculations and measurements of vacuum components for BEPCII storage rings[D]. Beijing: Institute of High Energy Physics, Chinese Academy of Sciences, 2005
[5]	Zhou Demin, Wang Jiuqing, Zhou Lijuan, et al. Longitudinal impedance measurements of the components for the BEPCII[C]//Proceedings of the 2005 Particle Accelerator Conference. Knoxville: IEEE, 2005: 3212-3214.
[6]	黄良生. CSNS/RCS束流集体效应及阻抗测量理论和实验研究[D]. 北京: 中国科学院大学, 2014 Huang Liangsheng. The theoretical and experimental study on the coupling impedance measurement and the collective effects in CSNS/RCS[D]. Beijing: University of Chinese Academy of Sciences, 2014
[7]	王琳, 徐宏亮, 冯光耀. 同轴线方法测量束流耦合阻抗的有效性分析[J]. 强激光与粒子束, 2002, 14(6):920-924. (Wang Lin, Xu Hongliang, Feng Guangyao. Validity of coaxial-wire method in impedance measurement[J]. High Power Laser and Particle Beams, 2002, 14(6): 920-924
[8]	Toyomasu T, Izawa M, Kamiya Y. Effect of a wire on the electromagnetic field in an accelerating cavity in the coaxial-wire method[J]. Japanese Journal of Applied Physics, 1995, 34: 340. doi: 10.1143/JJAP.34.340
[9]	Argan A, Palumbo L, Masullo M R, et al. On the Sands and Rees measurement method of the longitudinal coupling impedance[C]//Proceedings of the 1999 Particle Accelerator Conference (Cat. No. 99CH36366). New York: IEEE, 1999.
[10]	Jiao Yi, Xu Gang, Cui Xiaohao, et al. The HEPS project[J]. Journal of Synchrotron Radiation, 2018, 25(6): 1611-1618. doi: 10.1107/S1600577518012110
[11]	Wang L, Chen J H, Shi H, et al. A novel 5-cell strip-line kicker prototype for the HEPS on-axis injection system[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2021, 992: 165040. doi: 10.1016/j.nima.2021.165040
[12]	Wang N, Tian S K, Wang L, et al. Impedance optimization and measurements of the injection stripline kicker[J]. Physical Review Accelerators and Beams, 2021, 24: 034401. doi: 10.1103/PhysRevAccelBeams.24.034401