Research on crosstalk simulation of high and low voltage wiring harnesses in ground equipment power conversion system

Xiong Ying; Li Xiaojian; Wang Biao; Zhang Ying; Du Xiaolin; Nie Xiuli; Wang Tiannan

doi:10.11884/HPLPB202436.230276

Volume 36 Issue 4

Feb. 2024

Turn off MathJax

Article Contents

Article Navigation > High Power Laser and Particle Beams > 2024 > 36(4): 043023

Xiong Ying, Li Xiaojian, Wang Biao, et al. Research on crosstalk simulation of high and low voltage wiring harnesses in ground equipment power conversion system[J]. High Power Laser and Particle Beams, 2024, 36: 043023. doi: 10.11884/HPLPB202436.230276

Citation:

Xiong Ying, Li Xiaojian, Wang Biao, et al. Research on crosstalk simulation of high and low voltage wiring harnesses in ground equipment power conversion system[J]. High Power Laser and Particle Beams, 2024, 36: 043023. doi: 10.11884/HPLPB202436.230276

Citation:

PDF( 7111 KB)

Research on crosstalk simulation of high and low voltage wiring harnesses in ground equipment power conversion system

doi: 10.11884/HPLPB202436.230276

EMC Laboratory, China North Vehicle Research Institute, Beijing 100072, China

Received Date: 2023-08-18
Accepted Date: 2023-11-21
Rev Recd Date: 2023-11-21

Available Online: 2023-11-30

Publish Date: 2024-02-29

Abstract

Abstract

The high-speed switching of power devices such as MOSFETs and IGBT switches in power conversion systems will generate high amplitude and broadband electromagnetic interference (EMI), which is the most common and unavoidable EMI for electric vehicles. At the same time, interconnecting cables are the carrier of signals and energy transmitted by electrical devices, the antenna effect of cables is the main pathway for EMI radiation propagation, and is one of the main sources of system electromagnetic compatibility (EMC) problems. To analyze the electromagnetic coupling between the high-voltage power conversion system and the low-voltage control system, this paper takes the pulse width modulation (PWM ) wave generated by the IGBT as the EMI source, and uses the actual cable as the analysis object to construct a high and low voltage harness crosstalk model. The simulation analysis analyzes the near-end crosstalk voltage of multiple types of low voltage cable under different conditions of cable spacing and ground distance, obtains the anti-interference performance of low-voltage cables, thus provides guidance for the wiring of the system cable harness.
- cable harness,
- electromagnetic compatibility,
- power conversion system,
- harness crosstalk,
- common mode interference

FullText(HTML)

References(17)

References

[1]	Zheng Feng, Wang Wugang, Zhao Xiaofan, et al. Identifying electromagnetic noise-source impedance using hybrid of measurement and calculation method[J]. IEEE Transactions on Power Electronics, 2019, 34(10): 9609-9618. doi: 10.1109/TPEL.2019.2891170
[2]	龙海清. 电动汽车PWM驱动电机系统EMC研究[D]. 重庆: 重庆大学, 2014 Long Haiqing. Study on the EMC of PWM drive motor system of electric vehicle[D]. Chongqing: Chongqing University, 2014
[3]	Wang Biao, Sun Yongwei, Wei Guanghui, et al. Research on test method of ignition temperature of electric explosive device under electromagnetic pulse[J]. Radioengineering, 2021, 30(3): 510-516. doi: 10.13164/re.2021.0510
[4]	Wang Biao, Sun Yongwei, Wang Xuetian, et al. Equivalent test method for strong electromagnetic field radiation effect of EED[J]. International Journal of Antennas and Propagation, 2021, 2021: 7331428.
[5]	Gubia E, Sanchis P, Ursua A, et al. Frequency domain model of conducted EMI in electrical drives[J]. IEEE Power Electronics Letters, 2005, 3(2): 45-49. doi: 10.1109/LPEL.2005.848730
[6]	Kim T, Feng Dong, Jang M, et al. Common mode noise analysis for cascaded boost converter with silicon carbide devices[J]. IEEE Transactions on Power Electronics, 2017, 32(3): 1917-1926. doi: 10.1109/TPEL.2016.2569424
[7]	Grandi G, Casadei D, Reggiani U. Analysis of common- and differential-mode HF current components in PWM inverter-fed AC motors[C]//Proceedings of the 29th Annual IEEE Power Electronics Specialists Conference. 1998: 1146-1151.
[8]	冯冉冉. 电动汽车线束的电磁干扰建模与抑制技术研究[D]. 成都: 电子科技大学, 2021 Feng Ranran. Research on electromagnetic interference and suppression technology of electric vehicle harness[D]. Chengdu: University of Electronic Science and Technology of China, 2021
[9]	高建凯, 周德俭. 三维布线技术的电磁兼容性预测[J]. 现代表面贴装资讯, 2004, 3(5): 34-37 Gao Jiankai, Zhou Dejian. Microwave circuit interconnect and manufacture technology[J]. Modern Surface Mounting Technology Information, 2005, 3(5): 34-37
[10]	肖培. 机电设备互连线缆电磁干扰建模及计算方法研究[D]. 成都: 电子科技大学, 2019 Xiao Pei. Study on modeling and calculation method for the electromagnetic interference of interconnection cable in electromechanical equipment[D]. Chengdu: University of Electronic Science and Technology of China, 2019
[11]	林森. 线束串扰和抗扰性仿真在车辆上的应用[J]. 汽车实用技术, 2021, 46(14):35-38,109 Lin Sen. Application of crosstalk and immunity simulation in vehicle[J]. Automobile Applied Technology, 2021, 46(14): 35-38,109
[12]	汪泉弟, 安宗裕, 郑亚利, 等. 电动汽车开关电源电磁兼容优化设计方法[J]. 电工技术学报, 2014, 29(9):225-231 doi: 10.3969/j.issn.1000-6753.2014.09.032 Wang Quandi, An Zongyu, Zheng Yali, et al. Electromagnetic compatibility optimization design for switching power supply used in electric vehicle[J]. Transactions of China Electrotechnical Society, 2014, 29(9): 225-231 doi: 10.3969/j.issn.1000-6753.2014.09.032
[13]	Wang Kunbo, Lu Hongmin, Chen Chongchong, et al. Modeling of system-level conducted EMI of the high-voltage electric drive system in electric vehicles[J]. IEEE Transactions on Electromagnetic Compatibility, 2022, 64(3): 741-749. doi: 10.1109/TEMC.2022.3147521
[14]	Revol B, Roudet J, Schanen J L, et al. EMI study of three-phase inverter-fed motor drives[J]. IEEE Transactions on Industry Applications, 2011, 47(1): 223-231. doi: 10.1109/TIA.2010.2091193
[15]	Bondarenko N, Zhai Li, Xu Bingjie, et al. A measurement-based model of the electromagnetic emissions from a power inverter[J]. IEEE Transactions on Power Electronics, 2015, 30(10): 5522-5531. doi: 10.1109/TPEL.2014.2384030
[16]	Xiong Ying, Li Xiaojian, Li Yan, et al. A high-frequency motor model constructed based on vector fitting method[C]//Proceedings of 2019 Joint International Symposium on Electromagnetic Compatibility, Sapporo and Asia-Pacific International Symposium on Electromagnetic Compatibility. 2019: 191-194.
[17]	熊瑛, 李小健, 周伟, 等. 装甲车辆三相同步电机宽频电磁兼容模型构建方法[J]. 兵工学报, 2022, 43(7):1467-1477 Xiong Ying, Li Xiaojian, Zhou Wei, et al. Broadband electromagnetic compatibility modeling for three-phase synchronous motor of armored vehicle[J]. Acta Armamentarii, 2022, 43(7): 1467-1477