Research of positive and negative polarity pseudo-spark switches

Zhou Liang; Zhang Ming; Zhao Zheng; Di heyang; Yang Hongfei

doi:10.11884/HPLPB202436.240313

Volume 36 Issue 11

Nov. 2024

Turn off MathJax

Article Contents

Article Navigation > High Power Laser and Particle Beams > 2024 > 36(11): 115010

Zhou Liang, Zhang Ming, Zhao Zheng, et al. Research of positive and negative polarity pseudo-spark switches[J]. High Power Laser and Particle Beams, 2024, 36: 115010. doi: 10.11884/HPLPB202436.240313

Citation:

Zhou Liang, Zhang Ming, Zhao Zheng, et al. Research of positive and negative polarity pseudo-spark switches[J]. High Power Laser and Particle Beams, 2024, 36: 115010. doi: 10.11884/HPLPB202436.240313

Zhou Liang, Zhang Ming, Zhao Zheng, et al. Research of positive and negative polarity pseudo-spark switches[J]. High Power Laser and Particle Beams, 2024, 36: 115010. doi: 10.11884/HPLPB202436.240313

Citation:

PDF( 10531 KB)

Research of positive and negative polarity pseudo-spark switches

doi: 10.11884/HPLPB202436.240313

The 12th Research Institute of China Electronics Technology Group Corporation, Beijing 100016, China

Received Date: 2024-09-06
Accepted Date: 2024-10-08
Rev Recd Date: 2024-10-15

Available Online: 2024-10-25

Publish Date: 2024-11-01

Abstract

Abstract

This paper introduces a pseudo-spark switch which works in positive and negative polarity and does not need hot wire power supply. It can be triggered by one of the three modes of electric triggering, space light and fiber transmission laser energy. In the electric trigger mode, the technical specifications of the switch reach the operating voltage ±60 kV, the pulse current16.2 kA and the close jitter 7 ns; In space light trigger mode, the close jitter is 3 ns using 1 mJ/532 nm laser, and the minimum triggering laser energy is 0.15 mJ. In the fiber transmission laser energy mode (the energy of the incident end of the fiber is 7 mJ/the output end is 5 mJ), the close jitter is 3 ns.
- pseudo spark switch,
- positive and negative polarity,
- jitter,
- trigger mode,
- laser energy

FullText(HTML)

References(15)

References

[1]	邱爱慈. 脉冲功率技术应用[M]. 西安: 陕西科学技术出版社, 2016 Qiu Aici. Pulsed power technology applications[M]. Xi’an: Shaanxi Science and Technology Press, 2016
[2]	邱毓昌. 伪火花开关的发展与应用[J]. 电工电能新技术, 1997, 16(4):10-13,19 Qiu Yuchang. Development and applications of pseudospark switches[J]. Advanced Technology of Electrical Engineering and Energy, 1997, 16(4): 10-13,19
[3]	Heine F, Prucker U, Frank K, et al. Pseudospark switches (PSS) for pulsed power applications[C]//Proceedings of the 1996 11th International Conference on High-Power Particle Beams. 2012: 603-606.
[4]	Frank K, Petzenhauser I, Blell U. Multigap pseudospark switches for high voltage applications[C]//Proceedings of Conference Record of the 2006 Twenty-Seventh International Power Modulator Symposium. 2006: 445-448.
[5]	谢建民, 邱毓昌, 孙岩洲. 伪火花放电开关电压跌落过程实验研究[J]. 强激光与粒子束, 2003, 15(5):513-516 Xie Jianmin, Qiu Yuchang, Sun Yanzhou. Investigation on voltage collapse characteristics of the pseudospark switch[J]. High Power Laser and Particle Beams, 2003, 15(5): 513-516
[6]	孙国祥, 申赛康, 闫家启, 等. 伪火花放电初始阶段电势势垒形成的仿真研究[J]. 高电压技术, 2022, 48(1):358-365 Sun Guoxiang, Shen Saikang, Yan Jiaqi, et al. Simulation investigation on the formation of potential barrier in the initial stage of pseudospark discharge[J]. High Voltage Engineering, 2022, 48(1): 358-365
[7]	谢建民, 邱毓昌. 伪火花放电开关的陶瓷表面放电触发研究[J]. 强激光与粒子束, 2003, 15(2):199-202 Xie Jianmin, Qiu Yuchang. Ceramic surface flashover triggering of pseudospark switchs[J]. High Power Laser and Particle Beams, 2003, 15(2): 199-202
[8]	栾小燕, 张明, 周亮. 双间隙伪火花开关沿面放电触发材料的测试与研究[J]. 真空电子技术, 2014(2):14-17,27 doi: 10.3969/j.issn.1002-8935.2014.02.005 Luan Xiaoyan, Zhang Ming, Zhou Liang. A new pulse modulator device for large current-pseudospark switch[J]. Vacuum Electronics, 2014(2): 14-17,27 doi: 10.3969/j.issn.1002-8935.2014.02.005
[9]	秦风, 丁恩燕, 常安碧, 等. 辉光放电触发双级赝火花开关[J]. 强激光与粒子束, 2013, 25(s1):173-176 Qin Feng, Ding Enyan, Chang Anbi, et al. Two-staged pseudospark switch triggered by glow discharge[J]. High Power Laser and Particle Beams, 2013, 25(s1): 173-176
[10]	徐远灿, 刘庆想, 王庆峰, 等. 冷阴极闸流管的同步特性[J]. 强激光与粒子束, 2010, 22(4):717-720 doi: 10.3788/HPLPB20102204.0717 Xu Yuancan, Liu Qingxiang, Wang Qingfeng, et al. Synchronization characteristics of cold cathode thyratron[J]. High Power Laser and Particle Beams, 2010, 22(4): 717-720 doi: 10.3788/HPLPB20102204.0717
[11]	张国伟, 曾正中, 丛培天. 环槽电极结构的伪火花开关耐压特性[J]. 强激光与粒子束, 2007, 19(6):1016-1018 Zhang Guowei, Zeng Zhengzhong, Cong Peitian. Static breakdown voltage of psudospark switches with annular-slot and multi-hole electrode structures[J]. High Power Laser and Particle Beams, 2007, 19(6): 1016-1018
[12]	姚学玲, 陈景亮, 曾正中. 高介碳酸钡陶瓷沿面闪络伪火花开关的研究[J]. 高压电器, 2008, 44(1):47-49,52 Yao Xueling, Chen Jingliang, Zeng Zhengzhong. BaTiO₃ dielectric surface flashover triggering device of pseudospark switch[J]. High Voltage Apparatus, 2008, 44(1): 47-49,52
[13]	栾小燕, 张明, 周亮. 一种新型大电流脉冲调制器件——伪火花开关[J]. 真空电子技术, 2012(5):38-41,58 doi: 10.3969/j.issn.1002-8935.2012.05.009 Luan Xiaoyan, Zhang Ming, Zhou Liang. A new pulse modulator device for large current-pseudospark switch[J]. Vacuum Electronics, 2012(5): 38-41,58 doi: 10.3969/j.issn.1002-8935.2012.05.009
[14]	周亮, 张明, 孙承革. 激光触发伪火花开关的研究[J]. 强激光与粒子束, 2020, 32:035001 doi: 10.11884/HPLPB202032.190094 Zhou Liang, Zhang Ming, Sun Chengge. Preliminary study of laser-triggered pseudospark switch[J]. High Power Laser and Particle Beams, 2020, 32: 035001 doi: 10.11884/HPLPB202032.190094
[15]	张明, 栾小燕, 周亮. 双间隙伪火花开关沿面放电触发材料的研究[C]//中国电子学会真空电子学分会第十九届学术年会论文集. 2015 Zhang Ming, Luan Xiaoyan, Zhou Liang. Testing and research on surface discharge trigger material of double gap pseudo spark switch[C]//Annual Meeting of the Vacuum Electronics Society Branch of the Chinese Electronics Society. 2015