Development of ferrite high-order mode damper for High Energy Photon Source

Chen Xin; Li Chen; Zhao Wei; Xiang Jun; Li Tiantao; Huang Gang; Yang Jie; Liu Ping; Qin Zhen

doi:10.11884/HPLPB202537.240278

Volume 37 Issue 4

Mar. 2025

Turn off MathJax

Article Contents

Article Navigation > High Power Laser and Particle Beams > 2025 > 37(4): 044008

Chen Xin, Li Chen, Zhao Wei, et al. Development of ferrite high-order mode damper for High Energy Photon Source[J]. High Power Laser and Particle Beams, 2025, 37: 044008. doi: 10.11884/HPLPB202537.240278

Citation:

Chen Xin, Li Chen, Zhao Wei, et al. Development of ferrite high-order mode damper for High Energy Photon Source[J]. High Power Laser and Particle Beams, 2025, 37: 044008. doi: 10.11884/HPLPB202537.240278

Citation:

PDF( 10222 KB)

Development of ferrite high-order mode damper for High Energy Photon Source

doi: 10.11884/HPLPB202537.240278

Institute of Fluid Physics, CAEP, Mianyang 621900, China

Received Date: 2024-08-26
Accepted Date: 2025-03-03
Rev Recd Date: 2025-03-03

Available Online: 2025-03-29

Publish Date: 2025-04-15

Abstract

Abstract

In high-current accelerator beam tubes, the flow of charged particles induces a high-frequency field within the tube, which affects the current and stability of the beam. Additionally, this field leads to extra heat loss during the operation of the superconducting cavity, impacting its operational stability. Therefore, it is necessary to effectively control the high-order mode. This study employs ferrite as an absorbing material to absorb high-order modes. The ferrites were welded to copper substrates through metallization and brazing, and then they were joined with the copper beam tube and cooling system to create a ferrite high-order mode damper. The microwave performance of the ferrite high-order mode damper at various frequencies was simulated using CST software, and compared with the measured results. It is found that the high-order mode can be effectively suppressed in the test frequency band, but there are some differences between the two results in a certain frequency band. Additionally, COMSOL software was utilized to simulate the temperature distribution of the ferrite high-order mode damper during operation, and these simulations were compared with experimental data. The test results for loaded power show that the absorption efficiency reaches 77.4% when the absorbed power is 10.14 kW. Furthermore, results of vacuum leak rates, ultimate vacuum and water-resistant all conform to the design requirements for superconducting high-frequency cavities.
- high-order mode,
- damper,
- ferrite,
- welding,
- absorption efficiency

FullText(HTML)

References(17)

References

[1]	周文中, 潘卫民, 葛锐, 等. 中国散裂中子源二期双spoke超导腔设计[J]. 强激光与粒子束, 2023, 35:034004 doi: 10.11884/HPLPB202335.220266 Zhou Wenzhong, Pan Weimin, Ge Rui, et al. Design of the China Spallation Neutron Source phase II double spoke resonator[J]. High Power Laser and Particle Beams, 2023, 35: 034004 doi: 10.11884/HPLPB202335.220266
[2]	蒲小云, 侯洪涛, 马震宇, 等. 上海光源500MHz超导腔水平测试[J]. 强激光与粒子束, 2019, 31:115104 doi: 10.11884/HPLPB201931.190163 Pu Xiaoyun, Hou Hongtao, Ma Zhenyu, et al. Horizontal test of 500 MHz superconducting cavity for SSRF[J]. High Power Laser and Particle Beams, 2019, 31: 115104 doi: 10.11884/HPLPB201931.190163
[3]	米正辉, 沙鹏, 孙毅, 等. BEPC Ⅱ国产500 MHz超导腔运行综述[J]. 强激光与粒子束, 2018, 30:085103 doi: 10.11884/HPLPB201830.170485 Mi Zhenghui, Sha Peng, Sun Yi, et al. Operation of domestic 500 MHz superconducting cavity for BEPC Ⅱ[J]. High Power Laser and Particle Beams, 2018, 30: 085103 doi: 10.11884/HPLPB201830.170485
[4]	Hao Xuerui, Li Zhongquan, Ye Kuangkuang, et al. 500 MHz higher order mode damped cavity designed for 4th generation synchrotron radiation sources[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2022, 1040: 167273.
[5]	Wu Congfeng, Tang Yungai, Tan Mingsheng, et al. Research of the 499.8 MHz superconducting cavity system for HALF[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2023, 1050: 168176.
[6]	Nishiwaki M, Akai K, Furuya T, et al. Developments of HOM dampers for SuperKEKB superconducting cavity[C]//Proceedings of SRF2013. 2013: 1058-1060.
[7]	Moffat D, Barnes P, Kirchgessner J, et al. Design and fabrication of a ferrite-lined HOM load for CESR-B[C]//Proceedings of International Conference on Particle Accelerators. 1993: 977-979.
[8]	Huang Tongming, Pan Weimin, Wang Guangwei, et al. The development of the 499.8MHz superconducting cavity system for BEPCII[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2021, 1013: 165649.
[9]	Xu Wencan, Conway Z A, Daly E, et al. High-power test results for a cylindrical-shell silicon carbide higher-order-mode damper[J]. Physical Review Accelerators and Beams, 2024, 27: 031601. doi: 10.1103/PhysRevAccelBeams.27.031601
[10]	Alesini D, Bellaveglia M, Cardelli F, et al. Realization and high power test of damped C-band accelerating structures[J]. Physical Review Accelerators and Beams, 2020, 23: 042001.
[11]	Tajima T, Asano K, Furuya T, et al. Bonding of a microwave-absorbing ferrite, TDK IB-004, with copper for the HOM damper of the KEK B-factory SC cavities[C]//Proceeding of the 6th Workshop on RF Superconductivity. 1993: 1914-1916.
[12]	Terui S, Ishibashi T, Shirai M, et al. Development of ferrite higher order mode damper for SuperKEKB vacuum system[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2023, 1053: 168371.
[13]	Liu Zongkai, Chang Fuyu, Chang L H, et al. Design and optimization of the high order modes damper for a 1.5 GHz superconducting harmonic cavity[J]. IEEE Transactions on Applied Superconductivity, 2021, 31: 3500605.
[14]	Ego H, Tanaka H, Inagaki T, et al. Compact HOM-damping structure of a beam-accelerating TM020 mode rf cavity[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2024, 1064: 169418.
[15]	Hahn H, Ben-Zvi I, Belomestnykh S, et al. HOMs of the SRF electron gun cavity in the BNL ERL[J]. Physics Procedia, 2015, 79: 1-12.
[16]	Marhauser F. Next generation HOM-damping[J]. Superconductor Science and Technology, 2017, 30: 063002.
[17]	陈欣, 李晨, 赵伟, 等. 加速器用铁氧体-碳化硅混合型高次模阻尼器的研制[J]. 强激光与粒子束, 2025, 37:024001 doi: 10.11884/HPLPB202537.240154 Chen Xin, Li Chen, Zhao Wei, et al. Development of a ferrite-silicon carbide hybrid high-order mode damper for accelerators[J]. High Power Laser and Particle Beams, 2025, 37: 024001 doi: 10.11884/HPLPB202537.240154