Research on X-ray beam position monitor front-end acquisition circuit of high energy photo source
-
摘要: X射线位置探测器(XBPM)可用于光束线同步辐射光位置的测量,其中XBPM前端采集电路主要用于模拟信号采集与处理。为满足高能同步辐射光源(HEPS)光束线前端区对精确测量同步光位置信息的需求,研制了一款XBPM电子学模拟前端板卡(AFE),设计并实现了XBPM信号的电流电压转换、量程切换、增益控制和ADC采样等功能,并搭建实验室测试平台对XBPM-AFE进行了性能测试。测试结果表明,I/V转换模块电流输入范围为10 nA至1 mA,输入电流在三个数量级变化时,各量程段跨阻增益线性误差均保持在较低水准;四个通道之间测量结果的平均相对标准偏差小于0.46%;模数转换模块在慢采集和快采集两种模式下,分别可以准确地反映变化速度在0.1 s和1 ms以上的信号输入情况。Abstract: The X-ray beam position monitor (XBPM) can be used to measure the position of beamline synchrotron radiation light. The front-end acquisition circuit of XBPM is mainly used for analog signal acquisition and processing. To meet the demand for precise measurement of synchrotron light position information in the beamline front-end area of high energy photo source (HEPS), an XBPM electronic analog front end (AFE) board card has been developed in this paper. The functions such as current-voltage conversion, range switching, gain control and ADC sampling of XBPM signals were designed and implemented, and a laboratory test platform was built to conduct performance tests on XBPM-AFE. The test results show that the current input range of the I/V conversion module is from 10 nA to 1 mA. When the input current varies by three orders of magnitude, the linear error of the transimmer gain in each range segment remains at a relatively low level. The average relative standard deviation of the measurement results among the four channels is less than 0.46%. The analog-to-digital conversion module can accurately reflect the signal input conditions with changing speeds of over 0.1 s and 1 ms respectively in both slow acquisition and fast acquisition modes.
-
表 1 I/V转换模块测试结果
Table 1. I/V converter test results
gain range input current/μA output voltage/mV channel A channel B channel C channel D 1k 1000 1000 1001 1000 1001 500 499 500 500 500 200 200 200 200 201 100 100 100 100 100 50 50 50 50 50 20 20 20 20 21 10 10 10 10 10 10k 100 1000 1000 1000 1000 50 500 500 500 501 20 200 201 200 200 10 101 100 100 100 5 50 50 49 50 2 20 21 20 20 1 10 10 10 10 100k 10 999 1000 1001 1000 5 500 500 500 501 2 200 199 200 200 1 100 100 100 100 0.5 49 50 50 50 0.2 20 20 20 20 0.1 10 10 10 10 1M 1 1000 1000 1000 1000 0.5 500 500 500 501 0.2 200 200 200 200 0.1 100 101 100 100 0.05 50 50 49 50 0.02 19 20 20 20 0.01 10 10 10 10 表 2 I/V转换模块隔离度测试
Table 2. I/V conversion isolation test
input (channel A)/dBm output/dBm channel A channel B channel C channel D −10 −19.21 −95.68 −99.33 −100.47 -
[1] 焦毅, 潘卫民. 高能同步辐射光源[J]. 强激光与粒子束, 2022, 34:104002 doi: 10.11884/HPLPB202234.220080Jiao Yi, Pan Weimin. High energy photon source[J]. High Power Laser and Particle Beams, 2022, 34: 104002 doi: 10.11884/HPLPB202234.220080 [2] Xu Haisheng, Meng Cai, Peng Yuemei, et al. Equilibrium electron beam parameters of the High Energy Photon Source[J]. Radiation Detection Technology and Methods, 2023, 7(2): 279-287. doi: 10.1007/s41605-022-00374-w [3] 华冬, 余笑寒, 黎忠, 等. 上海光源光束位置探测系统的标定[J]. 核技术, 2009, 32(9):641-644 doi: 10.3321/j.issn:0253-3219.2009.09.001Hua Dong, Yu Xiaohan, Li Zhong, et al. Calibration of the XBPM system of SSRF[J]. Nuclear Techniques, 2009, 32(9): 641-644 doi: 10.3321/j.issn:0253-3219.2009.09.001 [4] Slivk A. Libera photon specification[M]. Solkan, Slovenia: Instrument Technologies, 2010: 15-16. [5] 龚培荣, 徐慧超, 周剑英, 等. 上海光源光束线前端区XBPM探测器[J]. 核电子学与探测技术, 2015, 35(3):281-286 doi: 10.3969/j.issn.0258-0934.2015.03.015Gong Peirong, Xu Huichao, Zhou Jianying, et al. The X-ray beam position monitor used in the front end of SSRF[J]. Nuclear Electronics & Detection Technology, 2015, 35(3): 281-286 doi: 10.3969/j.issn.0258-0934.2015.03.015 [6] 随艳峰, 杜垚垚, 叶强, 等. 基于BEPCⅡ数字束流位置测量系统电子学系统的设计与实现[J]. 原子能科学技术, 2020, 54(1):172-178 doi: 10.7538/yzk.2019.youxian.0044Sui Yanfeng, Du Yaoyao, Ye Qiang, et al. Development of digital beam position monitor electronics system based on BEPCⅡ[J]. Atomic Energy Science and Technology, 2020, 54(1): 172-178 doi: 10.7538/yzk.2019.youxian.0044 [7] 孙葆根, 林顺富, 何多慧, 等. 合肥光源光位置检测器的标定和应用(英文)[J]. 强激光与粒子束, 2006, 18(1):143-146Sun Baogen, Lin Shunfu, He Duohui, et al. Calibration and application of photon beam position monitor at HLS[J]. High Power Laser and Particle Beams, 2006, 18(1): 143-146 [8] 刘占军, 徐慧超, 龚培荣. Libera Photon处理器在上海光源XBPM中的应用研究[J]. 核技术, 2014, 37:050102 doi: 10.11889/j.0253-3219.2014.hjs.37.050102Liu Zhanjun, Xu Huichao, Gong Peirong. Research on application of Libera Photon processor for XBPM in SSRF[J]. Nuclear Techniques, 2014, 37: 050102 doi: 10.11889/j.0253-3219.2014.hjs.37.050102 [9] 张永立, 蒋建国, 龚培荣. 上海光源XBPM自动量程I-V转换器的研制[J]. 核电子学与探测技术, 2012, 32(6):686-689,714 doi: 10.3969/j.issn.0258-0934.2012.06.016Zhang Yongli, Jiang Jianguo, Gong Peirong. A automatic-ranging I/V converter design for X-ray beam position monitor of SSRF[J]. Nuclear Electronics & Detection Technology, 2012, 32(6): 686-689,714 doi: 10.3969/j.issn.0258-0934.2012.06.016 [10] 杨静, 杜垚垚, 汪林, 等. BEPC II直线加速器数字BPM前端调理电路的研制[J]. 强激光与粒子束, 2021, 33:054005 doi: 10.11884/HPLPB202133.210046Yang Jing, Du Yaoyao, Wang Lin, et al. Development of digital BPM front-end conditioning circuit for BEPCII linac[J]. High Power Laser and Particle Beams, 2021, 33: 054005 doi: 10.11884/HPLPB202133.210046 [11] 杜垚垚. HEPS数字BPM前端射频调理电路的研制[D]. 北京: 中国科学院大学, 2019Du Yaoyao. Development of RF front end for HEPS digital BPM[D]. Beijing: University of Chinese Academy of Sciences, 2019 [12] 高国栋, 唐旭辉, 曹建社, 等. 数字束流位置探测器系统的信噪比需求分析[J]. 强激光与粒子束, 2022, 34:064001 doi: 10.11884/HPLPB202234.210522Gao Guodong, Tang Xuhui, Cao Jianshe, et al. Signal-to-noise ratio requirement analysis for digital beam position monitor system[J]. High Power Laser and Particle Beams, 2022, 34: 064001 doi: 10.11884/HPLPB202234.210522 [13] Du Yaoyao, Yang Jing, Wang Lin, et al. Design of RF front end of digital BPM for BEPCII[J]. Radiation Detection Technology and Methods, 2019, 3: 38. doi: 10.1007/s41605-019-0119-x -